- Posts: 6
- Thank you received: 0
cascading in L3 switch
18 years 7 months ago #14022
by xtrenejl
cascading in L3 switch was created by xtrenejl
Hi all,
I have a cisco router 3560 switch and i need to setup a config where i have traffic generator connected to port 1 and port 2 of the switch. Both traffic supposed to map internally to port 3 of swich. Port 3 will then filter out the high priority packets and drop the lower priority packets. It will then be physically connected to port 4 and repeat the above scenario w the next port. The purpose is to load the router with the generator and mirror the last port to a sniffer program to anaylse the received packets. Does anyone know how to do it? Thanks in advance.
I have a cisco router 3560 switch and i need to setup a config where i have traffic generator connected to port 1 and port 2 of the switch. Both traffic supposed to map internally to port 3 of swich. Port 3 will then filter out the high priority packets and drop the lower priority packets. It will then be physically connected to port 4 and repeat the above scenario w the next port. The purpose is to load the router with the generator and mirror the last port to a sniffer program to anaylse the received packets. Does anyone know how to do it? Thanks in advance.
- kunaltyagi
- Offline
- Junior Member
Less
More
- Posts: 40
- Thank you received: 0
18 years 7 months ago #14096
by kunaltyagi
I'm an artist by living --- my art is my life
Replied by kunaltyagi on topic Re: cascading in L3 switch
u can create the ACCESS LISTS on the ports and then configure the sniffer program on the port where u want the management or analysing of packets to be done
I'm an artist by living --- my art is my life
Time to create page: 0.111 seconds