ASA 5505 Static NAT help

Hi everyone,

Your help will be greatly appreciated!

I am new to Cisco products and trying to configure a ASA5505 firewall.

I am trying to access a web server (ip: 10.20.30.12) hosted on the inside network (10.20.30.10/255.255.255.0) from the outside network (192.168.144.1/255.255.255.0). I believe I have implemented the required ACL and Static NAT rule. But, I am unable to access the web server from outside.

Note: firewall licensing has DMZ restricted. I can access the outside network from inside.

Here is the firewall configuration:

ASA Version 8.0(4)
!
hostname ciscoasa
enable password xxxxxxxxxxxx encrypted
passwd xxxxxxxxxxxxxx encrypted
names
!
interface Vlan1
nameif inside
security-level 100
ip address 10.20.30.10 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 192.168.144.102 255.255.255.0
!
interface Vlan12
no forward interface Vlan1
nameif management
security-level 100
ip address 192.168.111.1 255.255.255.0
management-only
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
switchport access vlan 12
!
no ftp mode passive
access-list outside_access_in extended permit ip any any
pager lines 24
logging asdm informational
mtu outside 1500
mtu inside 1500
mtu management 1500
icmp unreachable rate-limit 1 burst-size 1
asdm image disk0:/asdm-613.bin
no asdm history enable
arp timeout 14400
global (outside) 1 interface
nat (inside) 1 0.0.0.0 0.0.0.0
static (outside,inside) tcp 10.20.30.12 www 192.168.144.102 www netmask 255.255.255.255
access-group outside_access_in in interface outside
route outside 0.0.0.0 0.0.0.0 192.168.144.1 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
dynamic-access-policy-record DfltAccessPolicy
http server enable
http 192.168.111.2 255.255.255.255 management
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
telnet timeout 5
ssh timeout 5
console timeout 0
dhcpd auto_config outside
!
dhcpd address 10.20.30.11-10.20.30.42 inside
dhcpd enable inside
!

threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
!

Thank you!

Yay! I got it to work.

I had an incorrect implemention of Static NAT rule. Here is the correct rule that worked for me:

static (inside,outside) tcp interface www 10.20.30.12 www netmask 255.255.255.255

cheers,
Ledition