ASA 5505 unable to connect after power failure during flash

Hi All

Noobie to this forum.

In lamens I was flashing my 5505 last night when the power went down. Now I am unable to connect to the ASDM or via Telnet.

Any ideas? I'm of the assumption I can control break during boot but am stuck from here on

regards
c

In lamens I was flashing my 5505 last night when the power went down.

You were FLASHING the 5505 : Excuse my lack of knowledge here. Did you mean you were upgrading the IOS? ASDM? Or....?

Sorted now.

What I meant was when I was saving a config everything went tits.