- Posts: 10
- Thank you received: 0
remote access vpn troublshooting
16 years 9 months ago #25330
by Sheikh
remote access vpn troublshooting was created by Sheikh
hi every body,
i m facing a problem during configuring remote access vpn over the ASA, usually i did not face a problem like this.
i can connect to the vpn ip address has been assign to me, but i cant access any thing after that,
i m not very much familier to the new IOS but i have done so many times with pix & other firewalls,
advice plz...
i m facing a problem during configuring remote access vpn over the ASA, usually i did not face a problem like this.
i can connect to the vpn ip address has been assign to me, but i cant access any thing after that,
i m not very much familier to the new IOS but i have done so many times with pix & other firewalls,
advice plz...
16 years 9 months ago #25339
by Redpix
Replied by Redpix on topic Re: remote access vpn troublshooting
Hi,
I could figure out that you were able to access the pee ip but unable get to the inside network, is it?
Well , did you add the route from your inside to the remote ip or did you apply acl to permit your network to the remote i mean i could'nt figure out where you are stuck actually so only asking you al this.
well even i am naive to this tuneling i can just he;p you some extent . can you explain me howand what all you actually did so that i ll try to figure out..
Thanks
>>Bye
#REdpix.
I could figure out that you were able to access the pee ip but unable get to the inside network, is it?
Well , did you add the route from your inside to the remote ip or did you apply acl to permit your network to the remote i mean i could'nt figure out where you are stuck actually so only asking you al this.
well even i am naive to this tuneling i can just he;p you some extent . can you explain me howand what all you actually did so that i ll try to figure out..
Thanks
>>Bye
#REdpix.
16 years 9 months ago #25342
by Torvald
Replied by Torvald on topic Re: remote access vpn troublshooting
Could you post your config, that would help a lot to trouble shoot this.
Time to create page: 0.120 seconds