Need help on my network...

Hi, i'm just new to this CISCO. I'm trying to configure my 1st network which is:

Did all the subnetting to the ip class: 192.168.0.0/24

4 routers (ring topology):
192.168.0.24/30 - router 1
192.168.0.28/30 - router 2
192.168.0.32/30 - router 3
192.168.0.36/30 - router 4

Network A:
192.168.0.1/28
- connected to router 1
- connected to switch A
Network B:

192.168.0.16/29
- connected to router 3
- connected to switch B

I have already configured but it's not working. I can do pings on the same network. But when i try to ping a host on the other network is not working. any ideas that i need to check with my configuration? thanks.

Your going to need to provide more information.

I would start by putting the results of show run in for each node into a paste bin.


In the mean time here is a good example of how to configure the most common routing protocols.

what you need to do is tell the router how to reach the host connected to another router.

you do this by configuring either a static route or any routing protocol you know.

I suggest you read more about default gateways, static routes or dynamic routes.
hope this helps abit.