Skip to main content

HWIC-4T1/E1 problem

More
16 years 1 month ago #27660 by pp1dt
HWIC-4T1/E1 problem was created by pp1dt
Dear All

I had some small problem here, Just got 2 new Cisco C2851 router and installed with 4 ports HWIC-4T1/E1 card.

when I do show run for the IOS, the router unable to detect the new HWIC-4T1/E1 card, only shown the 2 Gigabits ethernet interface.

Any one have information how to configure the HWIC-4T1/E1 card, thanks in advance.

:)
More
16 years 1 month ago #27664 by S0lo
Replied by S0lo on topic Re: HWIC-4T1/E1 problem
Hi pp1dt, I'm sure you tried this but just in case.

1. Un-insert and reinsert your HWIC. And try again.
2. Try inserting it into and other slot.

If nothing works. I think there is either a hardware problem in the HWIC or the router slots. Did you try other WICs on your router? Do they work?

Studying CCNP...

Ammar Muqaddas
Forum Moderator
www.firewall.cx
More
16 years 1 month ago #27706 by Patiot
Replied by Patiot on topic Re: HWIC-4T1/E1 problem
Please ensure that you are having the following IOS versions or later :
Minimum IOS Requirements :

• 12.4(11)XW5
or
• 12.4(20)T

For clarifications please visit the following link :

www.cisco.com/en/US/prod/collateral/modu...900aecd80710c77.html

Let me know if this helps

Thanks
Patiot
More
16 years 1 month ago #27726 by pp1dt
Replied by pp1dt on topic Re: HWIC-4T1/E1 problem
Thanks, downloaded the IOS 12.4(20)T and the router can see the Interface cards already.

But do you know how to configure the point to point link E1 link, I try to search cisco website for help but the answer are very limited.

:)
More
16 years 1 month ago #27753 by Patiot
Replied by Patiot on topic Re: HWIC-4T1/E1 problem
Could you please elaborate your need, I will see if i can help

Thanks
Patiot
More
16 years 3 weeks ago #27967 by pp1dt
Replied by pp1dt on topic Re: HWIC-4T1/E1 problem
Thanks, now I can configure the E1 microwave point to point link, it work already.

Thanks,
Danny
Time to create page: 0.134 seconds